Labscope measurement

Get help by our specialists and community members.
Post Reply
Udo Braxas
Posts: 1
Joined: Tue Feb 09, 2021 4:35 pm

Labscope measurement

Post by Udo Braxas »

Configuration: Stemi 305, Axiocam Color, Labscope 3.2

When measuring a distance, the distance is always measured in PIXEL, no matter what I specify in the Labscope settings (Micrometer ...).
How and where can I set to measure in a different unit of measure.
Thanks Udo
Maik Drabent
Posts: 24
Joined: Wed Jun 10, 2020 2:33 pm

Re: Labscope measurement

Post by Maik Drabent »

Hello Udo,

please can you check in the image view if a objective magnification is shown in the lower left side? (Please see attachment)
This is a prerequisite that the measurement with different unit works.

If you not see an objective then please try to load another czi image and check if the measurements works fine
Which camera do you use exactly?

With best regards
Maik Drabent
Attachments
Example image with mm measurement.png
Example image with mm measurement.png (260.57 KiB) Viewed 359 times
Post Reply