Hi,
I start with:
cam = Zen.Acquisition.ActiveCamera.ReadCameraSetting()
Afterwards I set some parameters, either via Zen.Acquisition.ActiveCamera.Exposure/Binning etc, or via cam.SetParameter('Parameter', 'Value'). The first case works directly but the other way need to be applied as it seems. However, if I try to apply it then it complaints that it first needs to be saved. It seems a bit odd when comparing with how it works for the HardwareSettings. So the method is reading the active settings, changing parameters, saving, and finally applying to make it work?
I also noticed that when using one macro where one specific camera setting is loaded then it appears as I am able to ran another macro, starting with "cam = Zen.Acquisition.ActiveCamera.ReadCameraSetting()") and using cam.SetParameter(), which then seems to work instantly...
It would be nice if the colormode could be changed via a direct function, like binning and exposure time.
Best regards
Fredrik Olsson